Declarations, Two year warranty, Information for returning pumps – Watson-Marlow 403U User Manual
Page 2: Safety
2
Declarations
Declaration of
conformity
When this pump unit is used as a stand-alone pump it complies with: Machinery Directive
2006/42/EC, EMC Directive 2004/108/EC.
Declaration of
Incorporation
When this pump unit is to be installed into a machine or is to be assembled with other machines
for installations, it must not be put into service until the relevant machinery has been declared in
conformity with the Machinery Directive 2006/42/EC.
Responsible person: Christopher Gadsden, Managing Director, Watson-Marlow Limited, Falmouth, Cornwall
TR11 4RU, England. Telephone +44 (0) 1326 370370. Fax +44 (0) 1326 376009.
Two year warranty
W-M Alitea AB warrants, subject to the conditions below, through either W-M Alitea AB, its subsidiaries, or its
authorised distributors, to repair or replace free of charge, including labour, any part of this product which fails within
two years of delivery of the product to the end user. Such failure must have occurred because of defect in material or
workmanship and not as a result of operation of the product other than in accordance with the instructions given in
this manual.
Conditions of and specific exceptions to the above warranty are:
Consumable items such as tubing, rollers and motor brushes are excluded.
Products must be returned by pre-arrangement carriage paid to W-M Alitea AB, its subsidiaries, or its authorised
distributor.
All repairs or modifications must have been made by W-M Alitea AB, its subsidiaries, or its authorised distributors
or with the express permission of W-M Alitea AB, its subsidiaries, or its authorised distributors.
Products which have been abused, misused, or subjected to malicious or accidental damage or electrical surge
are excluded.
Warranties purporting to be on behalf of W-M Alitea AB made by any person, including representatives of W-M Alitea
AB, its subsidiaries, or its distributors, which do not accord with the terms of this warranty shall not be binding upon
W-M Alitea AB unless expressly approved in writing by a Director or Manager of W-M Alitea AB.
Information for returning pumps
Equipment which has been contaminated with, or exposed to, body fluids, toxic chemicals or any other substance
hazardous to health must be decontaminated before it is returned to W-M Alitea AB or its distributor.
A certificate included at the rear of these operating instructions, or signed statement, must be attached to the outside
of the shipping carton.
This certificate is required even if the pump is unused. If the pump has been used, the fluids that have been in contact
with the pump and the cleaning procedure must be specified along with a statement that the equipment has been
decontaminated.
Safety
In the interests of safety, this pump and the tubing selected should only be used by competent, suitably trained
personnel after they have read and understood this manual, and considered any hazard involved.
Any person who is involved in the installation or maintenance of this equipment should be fully competent to carry out
the work. In the UK this person should also be familiar with the Health and Safety at Work Act 1974.
There are dangerous voltages inside the pump. If access is required, isolate the pump
from the mains before removing the cover.