VXL Instruments Itona C Series Thin Client - Service Manual - Manual (Page 9)

Replacing RAM 5
3
Replacing RAM
To replace RAM:
1. Remove the power adapter, pedestal and side cover . For more information see, section
‘Removing the Pedestal and Side Cover’ on page 3.
2. Apply isopropyl alcohol on the glue holding the RAM, pull the glue out using the nose pliers.
Figure 5: Remove Glue on the RAM Holder
3. Unlock the clip on either side of the RAM, by pushing it side ways simultaneously.
Figure 6: RAM Socket Clips
4. Remove the existing RAM from the socket by pulling it outward.
5. Insert the new RAM in the socket.
Note: Ensure that the new RAM is of the same dimensions as the existing RAM.