Verilink NetPath 2000 Product Manual - Manual (Page 25)

C o n f i g u r a t i o n 3-7
Subnet Mask Sets the address mask that delineates local subnet range. In most cases, the
factory-default range of 255.255.255.0 will suffice.
DHCP Serving Enables DHCP. If enabled, the user must enter an IP address range to be
served.
Values: OFF, ON
Serve Range From Sets the first address of the connected equipment served.
To Sets the last address of the connected equipment served. When combined with
“Serve Range From,” determines the number of addresses served.
VPN
The VPN settings are described below.
Mode Enables VPN to initiate or respond automatically upon usage (Normal) or
force responder mode (Listen) or initiate a tunnel (Initiate).
Values: Disabled, Normal, Listen, Initiate
Interface Selects which interface supports VPN tunneling. Set to Wireless, unless in
Test Mode.
Values: Wireless, Local-Mgt, Router
Gateway Sets Gateway address. Leave blank when using the wireless interface since, in
this case, the Gateway is provided through the PPP link.
Remote VPN Address Sets the address of the remote VPN unit. This address must match the remote
VPN termination device.
Gateway Sets the IP address of the routable Gateway to the remote terminating VPN
device.
Remote LAN Subnet Sets the remote subnet address on the unencrypted remote side of the tunnel.
Net-Mask Sets the remote LAN net-mask to narrow the range of remote network clients
contacted.
Local LAN Subnet Sets the local subnet address on the unencrypted local LAN side of the tunnel.
This address must match the router interface address described above.
Local LAN Net-Mask Sets the local LAN net-mask to narrow the range of local network clients
connected to the tunnel.
PFS Mode Enables or disables the Perfect Forward Secrecy (PFS) mode.
Values: OFF, ON
Key Life Sets the PFS Key Life update period in seconds. The default is 28800
seconds.