Danby Silhouette DWC166BLSRH - Manual (Page 7)

• It is recommended that you
do not install the wine cooler
into a corner (i.e. directly
beside a wall). This is to allow
the door to have a greater than
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to
damaging the door gasket.
• The rough cabinet opening
must be on a level floor area
and at least 26
7/8 ” (68.26cm)
deep* by 23 3/4 ” (60.33cm)
wide. The opening should also
have a height of at least 69
3/4 ”
(177.17cm).
• The electrical outlet may be
positioned from within either
side of the adjacent cabinetry,
or the rear of the shaded area
(as shown in Fig. B).
Important: If the electrical
outlet is surface mounted (not
flush) within the enclosure, the
depth requirement for the
installation may be affected.
• If the electrical outlet is locat-
ed inside the adjacent cabi-
netry, cut a 1
1/2 ” (3.81cm)
diameter hole to admit the
power cord.
5
Installation Instructions - Integrated Application
Preparing the
Enclosure
Tools You Will
Need
Carpenter’s
Square
Measuring
Tape
Level
Drill & Hole Saw set
Gloves Safety Glasses
Flashlight
*The listed depth requirement for the installation is assuming that the electrical outlet is located in the
adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
W A R N I N G !
While performing the
installations described in
this section; gloves, safety
glasses or goggles should
be worn.
Electrical Requirements
The appliance must be con-
nected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker
or time delay fuse.
IMPORTANT!
Door Swing
Do not include the door
within the enclosure; leave
it outside of the enclosure
to prevent the door swing
from being obstructed.
Instrucciones de Operación
Almacenamiento
de Vinos
¡ I M P O R TA N T E !
• La capacidad m á xima* de
la DWC166BLSRH es de
166 botellas de vino (de
750ml).
• Guarde el vino en botellas
cerradas únicamente.
* Cuando se guarden de
acuerdo con las
instrucciones.
Fig. E
Fig. D
Fig. C
32
Para aprovechar la capacidad
máxima de 166 botellas, éstas
deben colocarse alternadamente
en las trece (13) repisas superi-
ores como se muestra en la Fig.
C. Así se podrán almacenar
once (11) botellas de 750 ml en
cada una de las trece (13)
repisas.
Cada una de las dos (2) repisas
inferiores tiene capacidad para
siete (7) botellas de acuerdo a la
Fig. D.
La repisa superior tiene capaci-
dad para veinte (20) botellas de
vino cuando se colocan once
(11) botellas alternadas de
acuerdo a la Fig. C; y luego otras
nueve (9) botellas alternadas
encima y entre las once (11)
botellas de abajo, como se
muestra en la Fig. E.
}
}
}
}
69 3/4” /
177.17cm
26 7/8”* /
68.26cm
Electrical
Access: 2” /
3.81cm
Fig. B
23 3/4” / 60.33cm
Cabinets
must be
square
and
plumb.