Time-based control of the programmable output, I8:88, Page 15.3 – Venstar T1900 User Manual

Page 72

Press the UP button to
set the programmable
output for time based
operation. The digits in the
clock area will appear.

3 i

Page 15.3

Time-Based Control of the
Programmable Output

Possible TIME scenarios:
1) An exterior lighting system that needs to be energized every
day between the hours of 8pm and 1am.

2) A sprinkler system that needs to be energized every day
between the hours of 2am and 4am.

Continued on
the next page

Press

MODE

PROGRAM

MODE

Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.

Press the MODE button repeatedly
until this setup screen appears.

Note: Press the

MODE

button momentarily
to move through the
setup screens. Press
and hold the

MODE

button to move back-
wards through the
setup screens.

OFF Time = Temp = Aux

I8:88

Setup

To operate one of the MISC outputs using time-based operation, set
Advanced Setup step #31 (below) for Time

i8:88

. This extra output

will supply 24VAC to the selected MISC terminal, which is especially
useful for devices that require a start and stop time. Refer to page
14.4 - 14.5 for more details on programming this output.

This manual is related to the following products:

T1800