Tri Tool CBM-3 Counterbore Module - Manual (Page 10)

10
TRI TOOL INC.
92-0227 : Rev. 070529
OPERATION
Read the operating instructions carefully before attempting to operate the Model
CBM-3 Counterbore Module.
Always wear adequate eye protection when operating power tools.
INSTALLATION
Remove the five (5) Cap Screws from the front of the Tool Holder on the 600SB or
600RBL Clamshell.
Installing the Counterbore Module onto a Tool Holder
Place the Adapter Plate (P/N 24-0634 for the SB’s or P/N 24-1281 for the RBL’s) on
the top of the Tool Holder and tighten it down with the longer Cap Screws (P/N 33-
0066 for the SB’s or P/N 33-0081 for the RBL’s).
Place the Support block and Counterbore Assembly on top of the Adapter Plate and
tighten these down with the Cap Screws (P/N 33-0079).
Place the Counterbore Tool Bit in the Tool Holder Slot on the Boring Bar and tighten
it by using the Set Screws on the side of the slot.