Tri Tool CBM-2 Counterbore Module - Manual (Page 11)

11
Model CBM-2, Counterbore Module
92-0177 : Rev. 140226
WARNING:
WARNING:
Do not use a wrench or lever to obtain extra holding strength.
Do not force the feed.
If the feed pressure builds up too high, release the knob for 2 or 3 revolutions
before continuing.
When the counterbore is finished, release the Feed Knob and allow the Clamshell to
rotate 2 or 3 times to release the chip.
Retract the Tool Bit.
Remove the C’bore Module from the Clamshell.
Remove the Clamshell from the pipe as described in the appropriate Clamshell
instruction manual.