Tri Tool 576AC Chipless Sever Module - Manual (Page 9)

9 92-0854 : Rev. 030318
576AC Chipless Sever Module
CAUTION:
NOTE:
NOTE:
OPERATION
1. Rotate the Chipless Sever Module until the feed sprocket is in the proximity
of the tripper pin.
2. Set the tripper pin to engage the feed sprocket with a .020 - .030” gap from
the roof of the sprocket.
Tripper Pin Alignment:
CAUTION:
Correct alignment of the Feed Pin Feed Pin positioning
If the feed sprocket is not correctly aligned before operation, serious damage
could occur or destroy the Tripper Pin Assembly and/or the feed sprocket .
Do not bump the cutter wheels.
Cutting Wheel Replacement
To remove the cutting wheels, loosen the retaining set screws at the bottom of the
cutting arms.
Become familiar with the custom 576 AC SEVERMASTER™ before attempting to
operate.
Use eye protection at all times when operating this machine.
Use of dull cutter wheels, cutter wheels not manufactured by Tri Tool, Inc. or cutter
wheels not originally provided with the system may result in poor performance.
This also constitutes abuse of this machine and therefore voids the Tri Tool, Inc.
factory warranty.
Slowly rotate machine to insure that no machine parts violate the maximum rotating
diameter. Then increase RPM to cutting speed.