Tri Tool 404 & 424 Keymaster - Manual (Page 8)

8
TRI TOOL INC.
92-0767 : Rev. 990427
NOTE:
NOTE:
NOTE:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
The air supply for the KEYMASTER TM with an Air Motor should include an adequate
filter, regulator and lubricator (FRL).
The Air motor warranty is void if damage occurs from contaminated air or lack of
lubrication.
If the KEYMASTER TM is operated in the vertical position (End Mill up), it should be
turned upside down and the chips and/or other debris removed after each keyway has
been completed.
Tool life may be severely shortened, unless chips and/or other debris that have
been deposited on the Base Clamp/Rails during the machining operation are
removed.
Disassembly of the KEYMASTER TM will void the warranty, except when
performed by a TRI TOOL Inc. designated repair technician.