Tri Tool 404 & 424 Keymaster - Manual (Page 11)

11
Model KEYMASTER TM
92-0767 : Rev. 990427
4. Loosen the main housing clamping screws, leaving enough pressure on the Belleville
washers to get an accurate reading of the adjustment.
5. Unscrew one side adjustment screw and tighten the opposite one and watch the dial
indicator.
6. When the correct amount of movement is accomplished, tighten the opposite side
adjustment screw.
7. Tighten the main housing clamping screw.
8. Start the cut again until the desired keyway width is achieved.
9. When the keyway is satisfactory, unclamp the tool from the shaft.