Tri Tool 304 Tube Squaring - Manual (Page 12)

12
TRI TOOL INC.
92-0749 : Rev. 110328
NOTE:
Tool Bit Placement in the Cutting Head
All components should be clean and coated with a light film of oil prior to use. Use a
clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
Loosen the cap screw in the clamp bracket and rotate the motor handle to the
desired position.
Tighten the cap screw before turning the motor on.
Select the tool bit(s) required to machine the end configuration desired.
When performing a tube squaring operation the tool bit may be placed in any one of
the three Cutting Head slots.
When performing any separate machining operation such as facing, beveling or
counterboring, the tool bit may be installed in any one of the three Cutting Head
slots.
When performing any multiple machining operation such as facing, beveling or
counter-boring, the tool bit(s) should be installed with one in each slot.
The use of dull tool bits or tool bits not manufactured by TRI TOOL Inc.
may result in poor performance and may constitute abuse of this machine
and therefore voids the TRI TOOL Inc. factory warranty.