Installation – Tri Tool 302 Tube Squaring Micro Feed Assembly User Manual
Page 6
6
TRI TOOL INC.
92-0710 : Rev. 040218
INSTALLATION
REMOVING THE LEVER FEED ASSEMBLY
In order to install the micro-feed assembly onto the back of the Model 302, the
existing lever feed assembly must be removed.
Remove the two (2) cap screws from the back of the cover.
Remove the cover from the lever feed assembly.
Remove the Button head screw and capture washer from the end of the feed shaft.
Remove the four (4) cap screws from the flange on the lever feed system.
The lever feed assembly may now be removed.
The ball bearing on the end of the feed shaft may come off if it is loose, otherwise
leave it in place.
Feed Shaft
Main Housing
Ball Bearing
Cap Screw (4)
Cap Screw (2)
Cover
Capture
Washer
Button
Head
Screw
Lever Feed System
See also other documents in the category Tri Tool Equipment:
- 204B Cutting Head (9 pages)
- 204B Cutting Head (10 pages)
- 204B Cutting Head (9 pages)
- 212B Single Point Spring Hanger Assembly (8 pages)
- 204B Cutting Head (13 pages)
- 204B Cutting Head (36 pages)
- 204B Cutting Head (17 pages)
- 201BA Beveler (36 pages)
- 204B Elbow Mandrel (16 pages)
- 204B Beveler (45 pages)
- 204B Flange Facer (21 pages)
- 206B Elbow Mandrel (17 pages)
- 206B Flange Facer (22 pages)
- 206B Beveler (45 pages)
- 212B ID Tracking Module (17 pages)
- 206B Miter Mandrel (16 pages)
- 206B Sleeve Mandrel (13 pages)
- 208B Elbow Mandrel (20 pages)
- 208B ID Tracking Module (18 pages)
- 208B Miter Mandrel (20 pages)
- 208B Flange Facer (28 pages)
- 208B Sleeve Mandrel (15 pages)
- 212B Elbow Mandrel (16 pages)
- 214B Beveler Single Point Flange Facer (41 pages)
- 212B Flange Facer (22 pages)
- 212B Miter Mandrel (20 pages)
- 212B Single Point Hydraulic Motor Assembly (9 pages)
- 212B Single Point Flange Facer Miter Mandrel (28 pages)
- 212B Sleeve Mandrel (12 pages)
- 214B Elbow Mandrel (20 pages)
- 214B Flange Facer (23 pages)
- 214B ID Track Module (19 pages)
- 214B Miter Mandrel Head Kit (22 pages)
- 214B Sleeve Mandrel (13 pages)
- 236B ID Tracking Module (23 pages)
- 224B Miter Mandrel (27 pages)
- 224B Single Point (30 pages)
- 230B Beveler Flange Facer (16 pages)
- 230B ID Tracking Module (15 pages)
- 230B Lifting Frame (19 pages)
- 236B Miter Mandrel (25 pages)
- 301SP Tube Squaring (35 pages)
- 236B Single Point (32 pages)
- 302 Tube Squaring (31 pages)