Tri Tool 230B ID Tracking Module - Manual (Page 10)

10
TRI TOOL INC.
92-1018 : Rev. 060314
MAINTENANCE
All components should be cleaned and coated with light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
When the Model 230B IDTM is operated in such a manner that the tool block
collects debris while cutting, the Tool Holder, Lock Block and the feed screws should
be cleaned after each cutting operation.
CAUTION: Tool life may be severely shortened, unless chips and/or other debris
that have been deposited on the cutting head during the machining operation are
removed.
MAINTENANCE
Daily
When the unit is in daily operation wipe the unit down and spray with rust
preventive under sever humidity conditions.
Visually inspect for loose, missing, or damaged screws, etc.
Every 20 Hours
Disassemble the unit and wipe down the slide rails.
Clean and lubricate the slide rails.
Excess lubricant will collect grit and/or chips and tend to cause
jamming and/or damage to the slide rails.
STORAGE
When the ID Tracking Module is to be stored or if it will remain out of service for a
significant period of time, 30 days or more, it should be thoroughly cleaned,
lubricated and sprayed with a rust preventative prior to storage.