Tri Tool 208B ID Tracking Module - Manual (Page 13)

13
Model 208B IDTM (ID Tracking Module)
92-1494 : Orig. 100920
The Land width will be determined by the position of the Beveling Tool Bit in the
slot.
Slide the Facing Tool Bit up and down in the slot keeping the bottom of the Tool Bit
flat against the bottom of the slot.
Once the desired position has been achieved, then tighten all of the Set Screws
which make contact with the Facing Tool Bit.
Attach the proper power supply line to the Model 208B.
Check that the Air Supply (FRL) is installed and set properly.
Turn the Motor on and start cutting.
After the cut is finished, turn the Motor off to stop the Headstock rotation.
Tighten down the Travel Stop Set Screw and lock it against the wheel Bracket to
prevent the spring from releasing when removing the machine from the pipe.
Facing Tool Bit Land Width
Land Width
Tool Bit Movement