Tri Tool 208B ID Tracking Module - Manual (Page 10)

10
TRI TOOL INC.
92-1494 : Orig. 100920
NOTE:
NOTE:
Install the Mandrel Assy into the pipe.
Use the Standard Jaw Blocks, Ramps and Adapters with the Extended
Mandrel that's provided with the Model 208B IDTM Kit.
Position the ID Tracking Module Assy so that the Tracking Wheel is in contact with
the ID of the pipe.
Tightly lock the Retaining Plates in place with the Hold Down Screws from the back
of the Base Plate.
Tighten the Spring Draw Rod, but leave enough travel to accommodate out of round
pipe.
Make sure the Travel Stop Set Screw is retracted back flush with the bottom
of the Spring Bracket.
Install the Tool Bits in the ID Tracking Module.
Install the Beveling Tool Bit with the cutting edge on the centerline of the pipe or
tube.
Retaining Plates
Spring Draw Rod
Wheel Bracket
Travel Stop
Set Screw
Retaining Plates
Tracking Wheel
Base Plate
Hold Down Screws
Spring Bracket