Tri Tool 206B Miter Mandrel - Manual (Page 10)

10
TRI TOOL INC.
92-0448 : Orig. 930630
NOTE:
If it is not, loosen the Angular Offset Adjustment Screw(s) where the gap is small and
tighten the Angular Offset Adjustment Screw where the gap is wide.
Lightly tighten.
All (4) four of the Angular Offset Adjustment Screws must be used in
conjunction with each other.
All of the Screws must be slightly tight to allow movement.
If the Mandrel Shaft is to be drawn directly toward one Screw, this Screw must be
loosened far enough to allow for take up before the near screw is tightened.
Using a tape measure or a steel rule, keep the rear flange of the Miter Head roughly
centered while turning the Jackscrews to tighten them against the ID of the
workpiece.
Jam Nut Usage
Use the Wrenches provided to tighten all (4) four Jackscrews securely.
In larger size workpieces, the use of the Jam Nuts should be used for more stability.
Mount the Indicator Kit onto the Mandrel and tighten the Thumb Screws.