Tri Tool 201BA Beveler - Manual (Page 9)

9
Model 201BA BEVELMASTER TM
92-0631 : Orig. 960119
NOTE:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter or oil as
specified for the air motor.
Air supply for the Model 201BA with an Air Motor requires an adequate
filter/regulator/lubricator (FRL) to be used.
A maximum of 90-psi (621 kPa) line pressure is recommended.
Clean Up
The motor warranty is void if damage occurs from contaminated air or lack of
lubrication.
If the Model 201BA is operated in the vertical position (cutting head up), it should be
turned upside down and the chips and/or other debris removed after each bevel has
been completed.