Dixon 13087-0400 - Manual (Page 27)

Page 27
CARE AND MAINTENANCE
CAUTION HOT oil may cause burns. Allow engine to cool before draining oil.
CHANGING THE ENGINE OIL:
•Replace filter each time the oil is changed.
•These filters can be obtained from your authorized Briggs & Stratton engine
dealer (P/N 492 932).
•The use of any other oil filter may cause damage to the engine.
PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS.
PROTECT YOUR ENVIRONMENT
OIL FILTERS:
1. The "Dapco" oil drain valve is located on the left side of the engine crankcase.
2. Place a suitable container under the drain valve. The fitting of a short piece of hose will
help direct the oil.
3. To drain turn hex head valve stem counter clockwise with 10mm wrench or socket.
Open to full open (approximately 7 turns).
4. After engine is drained tighten hex stem..
NOTE: Refer to engine manufacturers recommendations for frequency of oil changes.
Hex Head Valve Stem
OIL FILL:
1. Drain oil.
2. Clean any spilled oil from engine and chassis.
3. Refill engine with type, and quantity of oil recommended by the engine manufacturer in
engine literature.