Replacing the internal clock battery – Dukane LCD Data Video Projector 8104HW User Manual

Page 20

Turn the projector off, and unplug the

power cord. Allow the projector to cool

sufficiently.

After making sure that the projector has

cooled adequately, slowly turn over the

projector, so that the bottom is facing.

Turn the battery cover fully in the direction

indicated “OPEN” using a coin or the like,

and pick the cover up to remove it.

Pry up the battery using a flathead

screwdriver or the like to take it out. While

prying it up, put a finger lightly on the

battery since it may pop out of the holder.

Replace the battery with a new HITACHI

MAXELL, Part No. CR2032 or CR2032H.

Slide the battery in under the plastic claw,

and push it into the holder until it clicks.

Replace the battery cover in place, then

turn it in the direction indicated “CLOSE”

using such as coins, to fix.

WARNING ►Be careful of handling a battery, as a battery can cause

explosion, cracking or leakage, which could result in a fire, an injury, and

environment pollution.

• Use only the specified and perfect battery. Do not use a battery with damage,

such as a scratch, a dent, rust or leakage.

• When replacing the battery, replace it with a new battery.

• When a battery leaked, wipe the leakage out well with a waste cloth. If the

leakage adhered to your body, immediately rinse it well with water. When a battery

leaked in the battery holder, replace the batteries after wiping the leakage out.

• Make sure the plus and minus terminals are correctly aligned when loading a

battery.

• Do not work on a battery; for example recharging or soldering.

• Keep a battery in a dark, cool and dry place. Never expose a battery to a fire

or water.

•

Keep a battery away from children and pets. Be careful for them not to swallow

a battery. If swallowed consult a physician immediately for emergency treatment.

• Obey the local laws on disposing a battery.

Replacing the internal clock battery

This projector has internal clock that uses a battery. When the clock of the network

function does not work correctly, please try solution by replacement of the battery:

HITACHI MAXELL, part number CR2032 or CR2032H.

NOTE • The internal clock will be initialized by removing the battery. For

setting the clock, see “Network Guide”. (20, 22)

OPEN

Battery Cover