Thermon PCS-COM - Manual (Page 5)

4
3.3.
Feed cable and ground through expediter
base as shown. Feed cable and ground
lead through grommet (above the crimp).
3.2.
Trim braid to approximately 76mm (3”).
Crimp 12/10 AWG compression lug to
ground braid and ground lead.
3.1.
Separate braid strands at edge of overjacket
and pull cable through opening.
Ground Lead Wire
12/10 AWG
Crimp Expediter
Base
Grommet
Ground
Lead
Cable
152mm
(6”)
Power connection for FLX-BC with braid only.
76mm
(3”)
Braid
3.4.
Slide expediter toward pipe and secure
using two (2) circumferential bands of
19mm (3/4”) wide tape.
3.5.
Place UL® label provided as shown,
locate on opposite side from rectangular
side opening.
Pip
e H
ea tin g C
ab le 1
34 N
HS X ® or FL X™ H ea tin g C ab le S ys tem
Ins tall C ab le p er N
EC A rti cle 42 7
Th erm on M an ufactu
rin
g C o.
10 0 Th erm
on D r., San Marco
s, Te xas 7866
6
1-8 00 -7 30 -4 32 8
P N 2 74 00
Tape Provided
Separately
UL Label
3.6.
Cut and remove primary insulation jacket.
3.7.
Skive outside of black matrix .
3.8.
Cut V-notch in matrix and pull bus wires
from matrix. Cut and remove center
matrix.
Do not cut bus wire strands.
117mm
(4-5/8”) Bus Wire
Primary Insulation
Ground Lead
Matrix
Ground Lead
Ground Lead
Ground Lead
Black Matrix
Matrix
PCS-COM In-line and T-Splice Kit
12/10 AWG
Crimp