Example settings – THD Electronics Flexi-50 User Manual
Page 7

THD FLEXI-50 INSTRUCTION MANUAL
7
Example Settings
Now that you know what the controls on the Flexi do, you’re ready to go ahead and
experiment with various settings. In case you’d like some example settings as launching
points for your own explorations, here are some settings contributed from experienced
Flexi users. As mentioned in the Quick Start section above, please keep the following
conventions in mind:
• There are no numbers on the dials, so knob positions are expressed in “clock face”
notation.
• “Full” means that the knob is turned clockwise to its limit. (Sometimes referred to as
“dimed” since it represents a value of “10” on numbered dials).
Dark and Smooth
Input: Lo
Bright: OFF
Master: OFF
Volume: 3:00 O’clock
Boost: OFF
Master Vol: N/A
Treble: 8:00 O’clock
Gain: Full (see below)
Cut: Full
Middle: Full
Tone: 12:00 O’clock
Power Mode: 20W
Bass: 12:00 O’clock
Notes: To switch between this dark and smooth setting, and a punchy tone with rich
breakup, turn on the Switch Input with Boost switch on the back of the Flexi.
Less Compressed
Input: Hi
Bright: OFF
Master: OFF
Volume: 2:00 O’clock
Boost: ON
Master Vol: N/A
Treble: 12:00 O’clock
Gain: Full
Cut: 3:00 O’clock
Middle: Full
Tone: 3:00
Power Mode: 50W
Bass: 10:00 O’clock
Notes: Turning the Treble to “full” and the Cut down thickens the sound.