Teo 8000 Series Installation - Manual (Page 3)

Tone Commander 8000 Series Terminal Adapters Page 3
5. Install the stand by inserting the tabs on the telephone into the large openings in the stand’s upper
slots, then pressing the stand toward the top of the telephone until it locks into place. The stand
can be installed in three positions: low desktop, high desktop, or wall mount, as shown below.
Low Desktop Position High Desktop Position
Wall Mount Position
6. Reconnect the line cord and verify that the Terminal Adapter is properly connected by checking the
software version from the Administration Options menu (SETUP → ADMIN → VERS → ADD-ON).
If the 8001TA, 8002TA, 8003TA, 8004TA, or 8005TA selection does not appear, contact Tone
Commander Customer Service at (800) 524-0024 or [email protected].
Telephone – Computer RS-232 Serial Connection
1. Plug the supplied serial cable (standard straight-through modem cable) into the serial connector on
the telephone base.
2. Plug the other end of the cable into the serial port that will be selected during the TSPI driver
installation. If the computer has a 25-pin serial connector, you will need to obtain a DB9-DB25
adapter.