Analog connections, Connecting to analog trunks, Position connectors – Teo UC Mini Server User Manual
Page 20
Teo UC Mini Server Installation Instructions
Page 20
13-280139 Rev. C
A
A
n
n
a
a
l
l
o
o
g
g
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
s
s
WARNING! RISK OF EQUIPMENT DAMAGE
!
The UC Mini Server supplies power on FXS device ports, and receives
power from the telephone trunks on FXO trunk ports.
Ensure that the correct UC Mini Server ports are used when connecting
analog trunks or station devices.
You will need to refer to the analog port numbers when configuring the system from the
UCM Admin Portal. The connector with the lowest numbered port is on the left when
facing the back of the UC Mini Server.
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
n
n
g
g
t
t
o
o
A
A
n
n
a
a
l
l
o
o
g
g
T
T
r
r
u
u
n
n
k
k
s
s
FXO ports connect to standard analog loop start (POTS) telephone trunks.
Your UC Mini Server may have 4-position connectors supporting one trunk, or 6-position
connectors supporting two trunks; follow the appropriate instructions below.
4
4
-
-
P
P
o
o
s
s
i
i
t
t
i
i
o
o
n
n
C
C
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
s
s
6
6
-
-
P
P
o
o
s
s
i
i
t
t
i
i
o
o
n
n
C
C
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
s
s
• Use the supplied yellow crossover
cord. Connect the 4-position plug to
the server, and connect the 6-position
plug to the analog trunk jack.
• Use the supplied line splitter cord as
shown to connect to two individual 6-
position trunk jacks.
The lower numbered trunk port is
labeled "Port N" on the cord, and the
higher numbered port is labeled "Port
N+1".