Tech Source Raptor DL-Lite Drivers for AIX - Manual (Page 13)

Chapter 3 – Software Installation
3-3
After installing the drivers, reboot the machine. Turn on the
machine and the AIX should now recognize the Raptor correctly.
You can verify this by entering the following command:
prompt% lsdisp
If a Raptor DL-Lite card is present in the system, this command
should return an entry like:
Note: The Raptor cards are identified by the operating system as
follows:
Raptor DL-Lite
rapdlt#
Where
#
is an instance number assigned by the operating system.
3.3 Configuring the Raptor as LFT Display
In order to use the Raptor card as the LFT display, use the
chdisp
command to change the current display device to the Raptor
device.
For Raptor DL-Lite, type the following:
prompt% chdisp [-d|-p] rapdlt0
DEV_NAME SLOT BUS ADPT_NAME DESCRIPTION
======== ==== === ========= ===========
rapdlt0 02 pci Raptor DL-Lite
Graphics
Adapter