beautypg.com

To resume speed, To vary the speed setting, To accelerate for passing – Dodge 2006 DR Ram SRT-10 User Manual

Page 118

background image

WARNING!

Leaving the Speed Control ON when not in use is
dangerous. You could accidentally set the system to
cause it to go faster than you want. You could lose
control and have an accident. Always leave the
system OFF when you aren’t using it.

To Resume Speed
To resume a previously set speed, push and release the
RESUME button. Resume can be used at any speed above
30 mph (50 km/h).

To Vary The Speed Setting
When the speed control is on, speed can be increased by
pressing and holding the ACCEL button. When the
button is released, a new set speed will be established.

Tapping the ACCEL button once will result in a speed
increase of 2 mph (3 km/h). Each time the button is

tapped, speed increases so that tapping the button three
times will increase speed by three increments.

Tapping the COAST button once will result in a speed
decrease of 1 mph (2 km/h). Each time the button is
tapped, speed will decrease. For example, tapping the
button 3 times will decrease the speed by 3 mph (6
km/h).

To decrease speed while the speed control is on, press
and hold the COAST button. Release the button when the
desired speed is reached, and the new speed will be set.

To Accelerate For Passing
Depress the accelerator as you would normally. When the
pedal is released, the vehicle will return to the set speed.

NOTE:

When driving uphill, at elevations above 2,000

feet (610 meters), or when the vehicle is heavily loaded
the vehicle may slow below the SET speed. If the vehicle
speed drops below (refer to the table below for the speed

118

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

This manual is related to the following products: