Tecfluid LD61N User Manual
Page 7
7
G1 or 1” NPT thread
LD61N ML
7.1 Safety
characteristics
Given that this instrument is group II, it is intended for use in places likely to become
endangered by explosive atmospheres, but not in mines. The category is 1G, that is, it is
intended for use in areas in which explosive atmospheres caused by mixtures of air and
gases, vapours or mists are present continuously, for long periods or frequently.
NOTE:
This instrument can not be installed in places with impact risk. Special caution
should be exercised in the installation and use to prevent any impact or fall of the device.
7.2 Exi
parameters
Marking
Ex ia IIC T4
Ex ia IIC T6
Specific parameters
Ui : 14 V
Pi : 1.3 W
Ui : 14 V
Pi : 1.3 W
See also other documents in the category Tecfluid Sensors:
- AMD For 2000 Series (4 pages)
- AMO For 6000 Series (4 pages)
- AMR For 6000 Series (4 pages)
- AMM For 6000 Series (8 pages)
- LT-AMD (4 pages)
- TR420 (8 pages)
- AD Series (4 pages)
- TH6 For M21 Series (12 pages)
- TH5 For DP Series (12 pages)
- AMM For DP Series (8 pages)
- FLOMAT Series (12 pages)
- FLOMID-MX (20 pages)
- XT5D (24 pages)
- MX4H (24 pages)
- FLOMID Series (8 pages)
- MX4 For FLOMAT Series (56 pages)
- LC Series (4 pages)
- LC40 Series (8 pages)
- LC-40 ADF (4 pages)
- MX4 For FLOMID Series (64 pages)
- LD61 (8 pages)
- LD60 (8 pages)
- LD61R (12 pages)
- LP Series (12 pages)
- TR2420 (12 pages)
- LT-APR (4 pages)
- LTL-AMM (4 pages)
- LTL-APR (4 pages)
- LTL-ADF (4 pages)
- VH35 AISI-316 (4 pages)
- MC01 4-20 mA input (12 pages)
- LU Series (28 pages)
- MT-02 (9 pages)
- MT03L (32 pages)
- MT03F (40 pages)
- CH420L (8 pages)
- CH420R (12 pages)
- CH420P (12 pages)
- CIP (4 pages)
- CIP II (8 pages)
- DFD-2 E (8 pages)
- APTM44 (6 pages)
- CI-420 (8 pages)