Tecfluid LC40 Series User Manual
Page 4
5. MAINTENANCE
Mechanical: Maintain the pivot shaft clean and remove dirt from the fork.
There is no preventive maintenance for the electrical or pneumatic part.
4. ELECTRICAL
CONNECTION
The limit switches of the LC40 series are provided of a terminal block in order to connect
the cables.
Before starting the electrical installation, make sure that the cable to be used is the right
size for the PG9 cable gland. This will guarantee that the instrument is perfectly sealed (it
is recommended the use of shielded pair wiring with an exterior diameter between 5 and 8
mm. The section of the cables inside will be 0,25 or 0,5 mm
2
).
Peel the outside insulation to free the inner cables. It is recommended to tin the ends of
the wires to avoid loose ends. Pass the cables through the cable glands and screw down
in the corresponding positions of the terminal strip. Once the wiring is finished make sure
that the cables are well gripped by the cable glands to maintain the degree of protection.
The different connection diagrams depending on the limit switch are the following:
3.1 AMD
3.2 AMM
3.3 AMR
1/Brown
2/Blue
4