Teac KS-6001 - Manual (Page 5)

5
KS-6001
Attaching the KS-6001 as a sub mixer
Locking pins (bottom) and sockets (top)
These locking
pins and sockets locate the KS-6001 in position when connect-
ing it to another unit. They are secured and released with the
locking levers
Multipurpose connector
This multipurpose connector carries
signals to and from the KS-6001 to the other unit. It is usually
recessed, but may be released by sliding the small silver lever
(marked RELEASE) using a small screwdriver or similar. Once
the connector has been released, it is locked in the “Up” posi-
tion but may be recessed again by sliding the release lever and
pressing down the connector until it locks at the recessed posi-
tion.
Connector cover
if the KS-6001 is being used as a stand-
alone unit, you should always replace the cover and retain it in
place with the screws provided. Keep the cover plate and the
screws whenever the KS-6001 is attached to another unit.
Note:
Large and small cushions that enable use with the KS-342
carrying case are supplied with this unit. These cushions are used
with the carrying case as shown in the accompanying illustration.
The large cushion should be used when the BP-3/8 (AA battery
pack) is used. The smaller cushion is used when using the BH-1
(NP-1 battery pack).
Multipurpose connector under cover
Locking pins/sockets
Locking levers