Teac K-07 - Manual (Page 27)

27
En
gl
is
h
USB input setting
Display: USB>***
o To use HIGH SPEED (HS_1 or HS_2) mode, dedicated driver soft-
ware must be installed on the computer. Download the driver
software from our website.
NOR
Connect using USB FULL SPEED mode.
The sampling frequencies that can be input are 32 kHz, 44.1 kHz,
48 kHz, 88.2 kHz and 96 kHz.
HS_1
Connect using USB HIGH SPEED mode.
The sampling frequencies that can be input are 32 kHz, 44.1 kHz,
48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz and 192 kHz.
HS_2
Connect using USB HIGH SPEED asynchronous mode.
The sampling frequencies that can be input are 32 kHz, 44.1 kHz,
48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz and 192 kHz.
In asynchronous mode, the clock signal of this unit is used for play-
back of the audio data transmitted from the computer.
o If skipping noise occurs during playback when set to HS_2, set
the unit to HS_1 instead.
Analog output setting
Display: A_OUT>***
RCA
Analog audio signals are output through the RCA jacks.
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT.
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT.
OFF
Analog outputs are disabled and the D/A converter is turned off.
XLR output gain setting
Display: XLR>***
+6dB
Set the XLR output level to double the RCA output level (+6 dB).
0dB
Set the XLR output level to the same level as the RCA output level
(0 dB).
o This setting only appears when the analog output is set to XLR2 or
XLR3.
o If the sound clips when set to “+6dB”, change the setting to “0dB”.
o Depending on the connected amplifier, either the “+6dB” setting
or the “0dB” setting might result in the same volume as the RCA
jack input.
Digital output setting
Display: D_OUT>***
o During Super Audio CD playback, this is automatically set to off.
ON
Turns the digital output on.
OFF
Turns the digital output off.