Teac RC-SS20 - Manual (Page 5)

RC-SS20
5
3–Use with an SS-R1 or SS-CDR1
Connect the SS-R1/SS-CDR1 rear panel CONTROL
I/O (PARALLEL) connector with the RC-SS20
REMOTE 1 connector using a suitable cable. (See
“Connection cable” on the previous page.)
CAUTION
When connecting an SS-R1/SS-CDR1 to the REMOTE 1 •
connector, do not connect anything to the REMOTE 2
connector.
Turn OFF the power of the SS-R1 or SS-CDR1 unit
•
before connecting or disconnecting the connection
cable. Connecting or disconnecting the cable while the
power is ON could cause malfunction.
Connecting with an SS-R1/SS-CDR1
Setting the SS-R1/SS-CDR1 recorder
Flash-starting tracks
Make the following settings.
Set the playback mode to •
Single
. (See
“Specifying the playback mode” in “5–Playback”
on page 24 of the SS-R1 Owner’s Manual or page
27 of the SS-CDR1 Owner’s Manual.)
Set the EOM function as necessary. (See “End of •
disc/track message (EOM)” in “5–Playback” on
page 33 of the SS-R1 Owner’s Manual or page 37
of the SS-CDR1 Owner’s Manual.)
The remaining time for the track or the playback •
area can be set as a trigger. This remaining time
trigger can be set to OFF or between 1–99 seconds.
Set the playlist or folder that contains the tracks •
that you want to flash start as the current playback
area. The first 20 tracks in the playback area
become available for flash start. (See “Play area”
in “5–Playback” on page 21 of the SS-R1 Owner’s
Manual or page 24 of the SS-CDR1 Owner’s
Manual.) (See also “Flash start function” on page
32 of the SS-R1 Owner’s Manual or page 36 of the
SS-CDR1 Owner’s Manual.)
1 Press the RC-SS20 LOAD/STOP key or the
remote control FLASH LOAD key, to load the
start data for the tracks in the playback area.
When loading completes, the RC-SS20 LOAD/
STOP key lights and the FLASH icon appears
at the bottom right of the home screen of the
SS-R1/SS-CDR1.
This completes the preparation.
If these procedures are not conducted, ordinary
direct play occurs instead, resulting in a little
time before the first sound is heard.
2 Press the playback key (1– 20) that corresponds
to the track that you want to flash-start.
The track begins playback instantaneously.
During playback, the key lights. When playback
ends the key indicator extinguishes.
CAUTION
The RC-SS20 indicators might not match the status of the
connected unit if that unit is set to any playback mode
other than Single or if operation is conducted from that
unit.
Playback keys (1–20)