Teac PD-501HR - Manual (Page 29)

29
EN
Troubleshooting (1)
If you experience a problem with this unit, please check
the following items before requesting service. If it still
does not operate correctly, contact the retailer where you
purchased the unit or TEAC customer support (see the
back cover for contact information).
General
The power will not turn on.
e Check that the power cord is completely plugged
into the power outlet. If the outlet is switched,
confirm that the switch is in the ON position.
e Connect a different electrical device to the outlet
to confirm that it is supplying power.
No sound is output.
e Confirm connections with the amplifier, receiver,
and speakers.
e Confirm the operation of the amplifier and receiver.
e In pure mode, no audio signals are output from the
digital output connectors (see page 28).
Remote control does not work.
e If the batteries are exhausted, replace both of
them with new ones.
e The remote control will not work if there is an
obstruction between it and the main unit. Point
the remote control toward the main unit and use
it within 5 m of the front panel.
A television set or another device operates in error.
e Some televisions that are able to receive sig-
nals from wireless remote controls might be
operated in error by this unit's remote control.
If this should occur, turn the other device's power
off when using this unit's remote control.
Playback is not possible.
e If the disc is upside down, reload it with the
labeled side up.
e If the disc is dirty, wipe it clean.
e Discs that do not have any recordings on them
or that have not been finalized cannot be played
back. Make sure that CD-ROM/R/RW and DVD-
ROM/± R/RW discs that you want to play back
have recordings on them and have been finalized.
e Depending on the quality and recording condi-
tions of the disc, some CD-ROM/R/RW and DVD-
ROM/± R/RW discs cannot be played back.
The sound skips.
e Vibrations can cause the sound to skip. Install this
unit in a stable location.
e If the disc is dirty, wipe it clean.
e Do not play any disc that is warped, deformed or
damaged.
Program playback is not possible.
e Turning the power off or ejecting the disc will
cause the program to be cleared. If you have acci-
dentally cleared the program, you will need to
reenter it.
Automatic power saving caused the unit to enter
standby.
e When in standby mode, press a button on this
unit or the remote control to turn the power ON.
Continued on the next page