Teac CD-H750 - Manual (Page 19)

19
EN
G
LI
SH
CD USB
Up to 32 tracks/files can be programmed in the desired order.
1 Press the PROGRAM button while in the stop mode.
When CD is selected
P-00 T000
T016 72:00
When USB is selected
P-00 T0000
Total File 0130
2 Use the SKIP buttons (.//) to select a track/file.
When CD is selected
P-01 T001
T016 72:00
When USB is selected
P-01 T0001
Total File 0130
You can also use the numeric buttons to select a track/file.
When you use the numeric buttons, just input the track/fiie
number.
After input, skip to step
4
Programmed playback (1)
For example, to select track/file number 25, press “2” first then “5”.
To select numbers less than 10, press “0” and then the number. As
an example, to select number 5, press “0” then “5”. (Optionally, you
may press just the number “5” and wait for a few seconds.)
3 Within 10 seconds, press the PROGRAM button.
When CD is selected
P-01 T012
T016 72:00
When USB is selected
P-01 T0012
Total File 0130
< Repeat steps 2 and 3 to program more tracks/files.
< If you make a mistake, press the CLEAR button.
The last programmed number will be deleted.
< Up to 32 tracks/files can be programmed. If you attempt to
program more than 32 tracks/files, “P-FULL (Program is full)” is
displayed and no more tracks/files can be programmed.
4 When you have finished programming, press the PLAY
button (y) to start programmed playback.
When playback of all the programmed tracks/files has finished, or
if the Stop button (H) or the STANDBY/ON button is pressed, the
program mode will be cancelled.
< If the unit is disconnected from the power supply, the programmed
contents will be erased.