beautypg.com

Storage, Engine, Pump – Delta A09733 User Manual

Page 15: Pressure washer

background image

15- ENG

A09733

1. Obtain a funnel, six ounces

of *RV antifreeze, and 16 - 36

inches of garden hose with a

male hose connector attached to

one end.

Use only RV

antifreeze. Any

other antifreeze is corrosive and

can damage pump.
2.
Disconnect spark plug wire.
3. Connect length of garden hose to

water inlet of pump.

4. Add *RV antifreeze to hose as

shown.

STORAGE

ENGINE

Consult the Engine Owners Manual for

the manufacturer's recommendations

for storage.

5. Pull engine starter rope slowly

several times until antifreeze

comes out of high pressure hose

connection of pump.

6. Remove garden hose from water

inlet of pump.

7. Reconnect spark plug wire.
*Windshield washer fluid may also be
used

PUMP

The manufacturer recommends using

a pump protector/winterizer when

storing the unit for more than 30 days

and/or when freezing temperatures

are expected. If a pump protector/

winterizer is not available, *RV

antifreeze needs to be run through the

pump as outlined in the steps below.
NOTE: Using a pump protector/

winterizer or *RV antifreeze is to

provide proper lubrication to the

internal seals of the pump regardless

of temperature or environment.

PRESSURE WASHER

1. Drain all water from high

pressure hose, coil it, and store

it in cradle of the pressure

washer handle.

2. Drain all water from spray gun

and wand by holding spray

gun in a vertical position with

nozzle end pointing down and

squeezing trigger. Store in gun

holder.

3. Store chemical hose so it is

protected from damage.

4. If space is needed, remove

handles and replace as shown.