Delta A09733 - Manual (Page 12)

12- ENG A09733
STARTING
Prior to starting, refer to your
engine manual for proper starting
procedure.
1. In a well ventilated outdoor area
add fresh, high quality, unleaded
gasoline with a pump octane
rating of 86 or higher. Do not
overfill. Wipe up spilled fuel before
starting the engine. Refer to
Engine Owners Manual for correct
procedure.
2. Check engine oil level. See
Engine Owners Manual for correct
procedure. NOTE: There will
be a slight amount of oil in the
engine from factory testing.
3. Verify
the filter
screen is in
water inlet
of pump.
NOTE:
Cone side
faces out.
4. Connect
water source to pump inlet.
NOTE: Water source must provide
a minimum of 5 gallons per minute
at 20 PSI.
5. Connect high pressure hose to
pump outlet.
6. If applying a chemical or
cleaning solution, see How
To Apply Chemicals/Cleaning
Solvents instructions in this
section.
7. Turn water source on.
NOTE: Failure to do so could
cause damage to the pump.
8. Start engine. See Engine
Owners Manual for correct
procedure. NOTE: When engine
rope is pulled, pressure starts
building in the gun. If the engine
does not start after two pulls,
pull the gun trigger to relieve this
pressure.
9. Depress trigger on gun to
start water flow. NOTE: Stand
on a stable surface and grip
gun/spray wand firmly with both
hands. Expect the gun to kick
when triggered.
NOTE: If using
the "Water
Vroom" surface
cleaning guide,
quickly and
effortlessly guide
it across the flat
surface being
cleaned.
10. Release trigger to stop water
flow.
11. Adjust spray for the task being
performed by changing quick
connect nozzle. See How To Use
Spray Wand instructions in this
section.
SHUTTING DOWN
1. After each use, if you have
applied chemicals, place chemical
hose into container of clean water
and draw clean water through
chemical injection system to rinse
system thoroughly. NOTE: Failure
to do so could cause damage to
the pump.
2. Turn engine off. See Engine
Owner’s Manual. NOTE: NEVER
turn the water off with the engine
running.
3. Turn water source off.
4. Pull trigger on spray gun to
relieve any water pressure in
hose or spray gun.
5. See Storage section in this manual
for proper storage procedures.
Water
Source
High
Pressure
Hose
Filter Screen