Digi XEB09-BCS - Manual (Page 5)

5
Advanced Operation
Contact Digi Support if your application requires:
• Over 16 SUs per AP for roaming/mobility
applications
• Multiple APs that use the same network key for
roaming/mobility
• Low packet loss rates when using broadcast or
multicast Ethernet packets.
Note: If possible, fixed IP addresses are recommended on your network. This is because broadcast
and multicast packets (e.g., DHCP, UDP) are sent once and may experience losses at extended range.
Unicast packets (e.g., HTTP, TCP) are sent using advanced error correction and retransmission
techniques to ensure delivery.
Technical Specifications
Characteristic Specification/Description
RF transmission rate 1.536 Mbps
Aggregate Throughput 935 Kbps
Output power +21dBm
Receive sensitivity -97dBm at lOe-4 BER
Ethernet Interface RJ45 10BaseT, Auto MDI/MDIX
Radio channels 12 Non-overlapping
Automatic frequency select Yes - radio channel automatically selected
and adaptively optimized
Manual frequency select Yes
Status LEDs Power, RF TX, RF RX, Ethernet Link,
6/Channel and 6/Link Quality
Error correction technique Sub-block error detection and retransmission
Adjacent-band rejection SAW receiver filter attenuates cellular and
pager interference.
Regulator type XEB09-BCS uses Linear Regulator and XEB09-
BIS uses Switching Regulator
Power consumption Transmit: XEB09-BCS 2W XEB09-BIS 1.5W
Receive:XEB09-BCS 1.2W XEB09-BIS 1.0W
Voltage XEB09-BCS: 5-7 VDC
XEB09-BIS: 9-48 VDC Power over Ethernet
Temperature range -40˚C to 70˚C (-40˚F to 158˚F)
Current draw XEB09-BCS:
350 mA
XEB09-BIS:
150mA at 9VDC
110mA at 12VDC
32mA at 48VDC
Radio Size XEB09-BCS: 5.5 in (14.0 cm) x 3.4 in (8.5
cm) x 1.2 in (3.0 cm)
XEB09-BIS: 7.9 in (20.0 cm) x 3.2 in (8.0
cm) x 2.1 in (5.5 cm)
Regulatory Approvals FCC ID (U.S. - Part 15.247) R4N-AW900M, IC
ID (Canada) 5303A-AW900M