Sundance SMT6060-TCPIP User Manual
Page 13
Revision 0.4
Page 13 of 13
Sundance Digital Signal Processing Inc.
4790 Caughlin Parkway 233, Reno, NV 89519-0907, U.S.A.
Tel: +1 (775) 827-3103, Fax: +1 (775) 827-3664, email:
www.sundancedsp.com
Figure 5 - Block properties
The second raw data section is cfg/netsocksvr/release.dat also with “big-endian” selected, and with an
ID value of 0xA50. (This is the netsocksvr application that will be loaded and run on the NET50
processor.)
Figure 6 - Block properties ID
4.1.1. Overwriting the default IP and MAC addresses
The SMT363 will automatically obtain an IP address from a DHCP server. The SMT363 will have a
MAC address of "00:40: AF: 00:42:06". If these values are acceptable, then you can skip this section.
If you do wish to overwrite the default values for the IP and MAC address, this can be done by specifying
a data section that is programmed with the SMT6001.
Create a file that is 20 bytes long, and that has the content shown: (An example is provided with this
installation package. See sampleconfig.dat)