Sundance SMT6060-TCPIP - Manual (Page 12)

Revision 0.4
Page 12 of 12
Sundance Digital Signal Processing Inc.
4790 Caughlin Parkway 233, Reno, NV 89519-0907, U.S.A.
Tel: +1 (775) 827-3103, Fax: +1 (775) 827-3664, email: [email protected]
www.sundancedsp.com
Figure 3 - SMT363 Configuration Data
There need to be two raw data sections as shown. The files used to create these data sections can be
found in the \cfg directory of your installation.
Figure 4 - SMT363 netbboot file selection
The first section should have an ID value of 0xB50. (The file is cfg/netboot_v4/netboot44mv4.bin).
(NOTE: Use netboot33mv4.dat for 33 MHz Net+50 boards)
If you need to add this data section, make sure that you select “big-endian” and an ID value of 0xB50.