Dynacord DRM 4000 - Manual (Page 25)

Legend to the table on the DRM 4000 FACTORY CONFIGURATION leaflet:
BASIC CONFIGURATION: The BASIC CONFIGURATION is active when no CONTROL
INPUT is connected to ground. The BASIC CONFIGURATION
always has the lowest priority.
CONTACT 1-8: The DRM 4000’s active configuration accords to the CONTROL
INPUT, which is connected to ground, as long as no other
CONTROL INPUT with a higher priority setting is connected
to ground.
PRIORITY: Each CONTROL INPUT has an assigned PRIORITY between
1 and 8. PRIORITY 0 - the lowest priority level - relates to the
BASIC CONFIGURATION. The CONTROL INPUT with the
highest priority setting is the active one (PRIORITY 8 represents
the highest priority level) when several CONTROL INPUTS
are connected to ground.
Routing: Off The input signal is not assigned to any output.
Mono A The input signal is only assigned to output A. AUX-inputs are
summed for monaural output.
Mono B The input signal is only assigned to output B. AUX-inputs are
summed for monaural output.
Dual The input signal is assigned to the outputs A and B.
AUX-inputs are summed for monaural output via the outputs
A and B.
Stereo AUX-input L is assigned to output A while AUX-input R is
assigned to output B. (this option is only available for AUX-inputs)
No Change The control input parameters are not changed from the BASIC
CONFIGURATION.
Mute: No Mute The output signal is connected through to the masters A resp. B.
Mute On Output relays switch the output signal off of masters A resp. B.
No Change The control input parameters are not changed from the
BASIC CONFIGURATION.
VCA: The MASTER outputs A resp. B are attenuated by the according
value in dB.
Priority Override: Enable MIC/LINE-input activates ducking control.
Disable MIC/LINE-input does not activate ducking control.
Ducking: Ducking Active Ducking control is activated by the contact.
Auto Ducking Ducking control is automatically activated, when the level in
MIC/LINE 1 or 2 is exceeding the Ducking Threshold (automatic
level detection function). Please note, that is a precondition
routing MIC/LINE 1 or 2 to the corresponding Master output and
setting the parameter Priority Override to Enable.
No Change The control input’s parameters are not changed from the
BASIC CONFIGURATION.
C O N F IGURING THE DRM 4000
8-2