Daewoo KOD-135P - Manual (Page 9)

8
once P-HI 100%
twice P-90 90%
3 times P-80 80%
4 times P-70 70%
5 times P-60 60%
6 times P-50 50%
7 times P-40 40%
8 times P-30 30%
9 times P-20 20%
10 times P-10 10%
11 times P-00 0%
The oven light is on when the microwave oven
is operating.
The oven door can be opened at any time
during operation by pressing the door release
button on the control panel. The oven will
automatically shut off.
Each time a pad is touched, a BEEP will sound
to acknowledge the touch.
The oven automatically cooks on full power
unless set to a lower power level.
The display will show ":0" when the oven is
plugged in.
Time clock returns to the present time when the
cooking time ends.
When the MWO PAUSE/CANCEL pad is
touched during the oven operation, the oven
stops cooking and all information retained.
To erase all information (except the present
time), touch the MWO PAUSE/CANCEL pad
once more. If the oven door is opened during the
oven operation, all information is retained.
If the START/EXPRESS COOK pad is touched
and the oven does not operate, check the area
between the door and door seal for obstructions
and make sure the door is closed securely.
The oven will not start cooking until the door is
completely closed or the program has been
reset.
OPERATION PROCEDURE (MICROWAVE OVEN)
This section includes useful information about microwave oven operation.
1. Plug power supply cord into a standard 3- pronged 15Amp, 230~240V 50Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
1
2
3
4
5
6
7
8
Make sure the oven is properly installed and
plugged into the electrical outlet.
When the oven is not in operation, touching
MWO pads will show MWO display and
touching pizza pads will show pizza display.
When the pizza oven is working, touching
MWO PAUSE/CANCEL pad can’t stop pizza
cooking.
WATTAGE OUTPUT CHART
• The power-level is set by touching the POWER LEVEL pad. The chart shows the display, the power level
and the percentage of power.
Touch POWER pad Power Level (Display) Approximate Percentage of Power