SP Controls PixiePlus User Manual
SP Controls Audio
This manual is related to the following products:
Table of contents
Document Outline
- PixiePlus DCM Installation Guide
- Contents
- Important Safety Instructions
- Electrical Warning
- I. Introduction
- II. Installation Overview
- III. Wiring PixiePlus to Display Device
- IV. PixiePlus Installation
- V. Program PixiePlus
- 1. Power the PixiePlus
- 2. Enter Learning mode
- 3. Test Remote Control and Identify Sweet Spot
- 4. Round Robin Codes and Macros
- 5. To Program a button with a single code
- 6. To program a button with multiple codes for macro or round robin commands
- 7. Verify Learned Keys
- 8. Repeat for Each Button
- 9. Set a button to Macro Mode
- 10. Controlling Multiple Units of the Same Device
- 11. Controlling Multiple Devices
- 12. To Erase All Buttons
- 13. To Exit Learning Mode
- 14. Final Test of Learned Codes
- 15. Troubleshooting
- VI. Configuring Special Features
- VII. Cloning
- VIII. Complete Installation
- IX. Operation
- X. Troubleshooting
- XI. Technical Specifications
- Warranty
- FCC Compliance
- Copyright