Smithco Wind Star Blower 55-100 (Sn W100) Parts & Service Manual User Manual

Page 7

CONTROL IDENTIFICATION & ASSEMBLY

1. PTO Shaft – Transfers power from the tractor to the SMITHCO Blower.

Make sure up or down angle of PTO shaft does not exceed 15 degrees.

2. Mount the Blower to the 3-Point hitch of the tractor.

3. Drive sheaves, belts, bearings and shields – All sheaves, belts and

bearings are driven by the PTO.

ASSEMBLY

1. Remove from crate

2. Connect PTO shaft to input shaft of machine, tighten screws on shaft.

3. Adjust casters with spacers provided to allow for proper ground clearance.

4. Mount Blower to 3-point hitch of tractor and connect PTO shaft.