Smithco Super Star 42-00x (sn 6310 – 6378/13820 – 13854) Parts & Service Manual - Manual (Page 78)

A-23
Front Attachment
42-315 REAR LIGHT MOUNT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 42-317 Light 1
42-317-01 Replacement Bulb 1
1a HSM-10-32-075 Machine Screw 10-32 x 3 /
4
2
1b HNFL-10-32 Flange Whiz Lock Nut 10-32 (not illustrated) 2
REAR LIGHT INSTALLATION
NOTE: The rear light of this kit must be installed in the position specified to prevent interference with the 42-210
Grader Blade Kit (if installed) on your machine.
1. Find the center of the seat panel. Measure down 3" on this center line and mark the centers for two, Ø 7 /
32
holes at the positions illustrated. Measure 1" above the previous two marks for the position of the Ø 3 /
8
hole.
2. Once the hole positions are marked proceed to drill the holes to the sizes specified.
3. Next, position Light (Ref. 1) with wires up, and using the #10 - 32 Machine Screws (Ref 1a) and #10 - 32
Whiz-Loc Nuts (Ref. 1b), mount the Light to the Seat Panel.
4. Run wires through the Ø 3 /
8
hole and connect according to the Wiring Drawing on the previous pages.