Smithco Sand Star Zee (ZTR) 45-500-A Operator Manual - Manual (Page 12)

10
Introduction
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
CONTROLS & INSTRUMENTS
A. Motion Control Levers - Two continuously variable control levers that move forward or backward
about a neutral position.
B. Center Lift Lever - Pull inward to release. Spring loaded back into lock position. Works in combina-
tion with left foot pedal.
C. Park Brake - Lift up to engage. Push down to disengage.
D. Center Lift Pedal - Push down to lift center attachment. Used in conjunction with center lift adjust-
ment lever.
E. Seat Adjustment - Lever below seat to move seat forward or back.
F. Manual Rear Attachment Lift Pedal /Lift Lever - used to lift and lower rear attachment manually.
G. Choke - Pull choke control knob up to close choke plate when starting a cold engine. A warm engine
may not require "choking" to start.
H. Ignition Switch - The ignition switch has three positions: Off-Run-Start.
I. Oil Light - The oil light should come on when ignition is on without engine operating. The oil light will
light when the oil pressure is low. If oil light should come on, shut off engine immediately and find the
cause.
J. Hand Throttle - The hand throttle is used to regulate engine speed.
K. Hour Meter - The hour meter indicates hours of machine operation. It operates only when the ignition
switch is on.
L. Light - (OPTIONAL) This is a holder for rocker switch to turn on and off lights.
M. Rake Holder - used to carry hand rake.
N. Cup Holder - Cup holder for large cup.