Smithco Sand Star Zee (ZTR) 45-500-A Operator Manual - Manual (Page 10)

8
Introduction
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
SETUP ASSEMBLY
The Sand Star Zee arrives from Smithco Smithco Smithco Smithco Smithco with some assembly required before service.
REAR WHEEL MOUNTING
1. Set park brake. Push the brake down past center and the park brake is engaged.
2. Block front tire. Jack up rear of machine being careful not to damage underside of machine. Place wheel
on hub lining up bolt holes. Use the ten lug nuts provided. Then torque to 64 - 74 ft/lb (87-100 Nm) using a
cross pattern. Retorque after the first 10 hours and every 200 hours thereafter. Lower machine to ground
and remove blocks and jack.
3. Check the tire pressure. The rear knobby tire pressure should be 5 psi (0.34 bar). The front castor wheel
should be 20psi (1.38 bar).
REAR HITCH LIFT ARM
1. You will need the 7 /
8
clevis and bridge pin from the
hardware bag.
2. The rear hitch lift arm is slid into the hitch on the back of
the machine between the adjustment bolts and held in
place with the
7 /
8
clevis and bridge pin .
3. Be sure hitch lift arm is on top of the hitch lift bar and the
lock and spring are on the top.
SEAT
1. Place the seat on the seat frame spacers.
2. Plug in seat switch.
3. Use four 5 /
16
whiz locks nuts from the hardware bag to secure
seat to the seat spacers. Tighten all bolts.
ROLL BAR
1. Mount the roll bar on the main frame just behind seat. There are
2 mounting plates with four holes in them. Use eight 7/16 bolt,
washer and lock nut, four on each side.
2. Roll bar should be leaning towards the back of the machine.
RAKE HOLDER
1. The rake holder is mounted on the right hand side of the
roll bar.
2. Measure up 7" from the roll bar mounting plate.
3. Use a u-bolt from the small parts bag to hold the rake
holder in place. Tighten all hardware.