Smart Avi StretcherPro-HD - Manual (Page 10)

10 www.smartavi.com
There are two primary modes of operation for StretcherPro-HD: Command Mode and CLI Mode.
When connecting to the StretcherPro-HD via RS-232, it will start in Command Mode. CLI Mode is
a more user- friendly way of operating the StretcherPro HD and includes instructional menus. The
following section details the use of the CLI Mode.
Using RS-232 Control (continued)
When you connect to the StretcherPro-HD to a computer via an RS-232 connection, you will see
the following screen on startup:
******StretcherPro-HD v.1.20.1*******
build date Mar 7 2014 10:53:44
…
…
StretcherPro-HD Initialization complete
CLI Mode: To enter CLI Mode type “clion” followed by the key and you will see the
following prompt:
CLI enabled!
To display the StretcherPro-HD help menu type “?” then key
Stretcher HD v.1.00.1 CLI command list
===================================================================
i List system information
f Full
dh Horizontal Dual
dv Vertical Dual
v VideoWall
o Output o [ 1-1080P60 | 2-720P | 3-1080P30 ]
rEDID Read EDID
wEDID < 1-ACER P241w | 2-Gateway FHX2300 | 3-local monitor>
reset Reset HDMV
losd load osd image
Frst Factory reset
? CLI command list
• To see the status of the input, press “i” then key.
• To read the EDID for an input, type in “rEDID” then .
• To program an EDID to the inputs, type in “wEDID N” then , where “N” is the EDID mode.
Ex. “wEDID 3” is to learn the EDID of the local monitor
• To do a power reset on the StretcherPro-HD, type “reset” followed by key.