DeLonghi PINGUINO PAC T110P - Manual (Page 10)

10
Operation
SETTING THE TIMER
The timer can be used to delay appliance start up or shut down. This avoids wasting electricity by
optimizing operating periods.
How to program delayed start up
•
Plug the appliance into a socket and press the ON/STAND BY (A) button, then select the requi-
red operating mode and other settings (temperature, fan speed, etc).
• Press the ON/STAND BY (A) button again to place the appliance in standby mode.
• Press the timer button (H). The two center segments flash on the display.
• Use the “+” (G) or “-” (P) buttons to set the number of hours delay before the appliance comes
on. The setting is increased or decreased by an hour at a time; however, when the buttons are
held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait
a few seconds for the data to be acquired.
• The indicator light (I) flashes until the appliance starts up.
• You can set the appliance to come on with a delay of up to 24 hours.
• To cancel the timer setting, press the timer button (H), and use the “-” (P) button to set the time
to “00”. The indicator light (I) will stop flashing.
How to program delayed shut down
•
Delayed shut down can be programmed in any operating mode.
• Press the timer button (H). The two center segments flash on the display.
• Use the “+” (G) or “-” (P) button to set the number of hours delay before the appliance goes
off.
The setting is increased or decreased by an hour at a time; however, when the buttons are
held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait
a few seconds for the data to be acquired.
• The indicator light (I) flashes until the appliance shuts down.
• To cancel the timer setting, press the timer button (H), and use the “-” (P) button to set the time
to zero. The indicator light (I) will stop flashing.