Skutt KilnMaster Kiln Unpacking Your - Manual (Page 2)

TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
SET UP
KM OPERATING MANUAL
REV 7/30/04
UNPACKING YOUR KILNMASTER KILN
6. Release the section latches on the side of the kiln.
7. Unstack the sections and lid if necceassary and place them on a clean, fl at surface.
Remove the lid using the instruction in the Lid Lifter Addendum in your operating
manual.
8. Position the kiln fl oor on top of the stand making certain that the weight is evenly dis-
tributed.
Notes on assembly. Make sure the stand and kiln fl oor are level and do not teeter. Leveling
problems may put unnecessary stress on the kiln during fi ring. To level the stand, place fi rm
shims under the legs (never above them touching the kiln). Center the kiln’s bottom slab on the
stand and double-check teetering.
9. One at a time, stack the sections on the kiln fl oor.
10. Secure the section latches.
11.
Return the kiln control box to the side of the kiln.
12. Slide the feeder wire connectors back into place being sure you match them in the posi-
tion they were removed.
13. Slide the thermocouple connectors back into place in their proper location.
14. Close the box, ensure the wiring is neatly routed and secure it with screws.
15. Replace lid using the instruction in the Lid Lifter Addendum in your operating manual.