Sensoray 311 - Manual (Page 9)

99
Slot and interrupt selection
JP3 (also marked A and B) is used to select the PC104+ module slot number. Refer to the table
below for the correct jumper setting.
Module Slot # JP3
Jumper B inserted Jumper A inserted
0 Yes Yes
1 Yes No
2 No Yes
3 No No
Jumpers JP5-JP8 are used to select an interrupt line used by the frame grabber. Refer to the
table below for the jumper settings.
Interrupt line used Jumper inserted
INTA JP5
INTB JP6
INTC JP7
INTD JP8
Note. Model 311 frame grabber does not require an interrupt line use for image capture. If,
however, it is preferred to use interrupts, one has to make sure that the interrupt line selected by
the jumpers on the 311 is not used by other hardware.