Sensoray 314 User Manual

Page 10

LED

Power-OK indicator, D8.

The LED D8 is used for indicating on-board Power-OK status.

Configuration DIP Switches

A/V routing DIP switch, SW1.

The DIP switch, SW1, is used for choosing audio input routing and video direct loopback routing.
Refer to the following chart to select the A/V routing that you prefer:

DIP

ON (down)

OFF (up)

SW1-5

J4-pin6 (AIN-R) == J1-R, and => both of
Audio-in Right1 and Right2 on PCI A/V decoder

Audio-in Right1 <= J4-pin6, and
Audio-in Right2 <= SteroeJack J1-R

SW1-4

J4-pin6 (AIN-L) == J1-L, and => both of
Audio-in Left1 and Left2 on PCI A/V decoder

Audio-in Left1 <= J4-pin7, and
Audio-in Left2 <= SteroeJack J1-L

SW1-3

Composite video out 1 <= Composite video in 1
or S-Video out 1 – Y <= S-Video in 1 – Y

No direct loopback (v-in1=>v-out1)
or (sv-in1-y => sv-out1-y)

SW1-2

Composite video out 2 <= Composite video in 1
or S-Video out 1 – C <= S-Video in 1 – C

No direct loopback (v-in2=>v-out2)
or (sv-in1-c => sv-out1-c)

SW1-1

Composite video out 3 <= Composite video in 1

No direct loopback (v-in3=>v-out3)

Note: in the chart, == presents connected; <= presents “take from”; => presents “pass to”.

PCI slot # select and interrupt routing DIP switch, SW2.

The DIP switch, SW2, is used for selecting PCI slot number and interrupt routing for the Model
314.

Refer to the following tables to choose a right/preferred setting for Model 314 in a (your) PC/104+
stack:

SW2-2 (SelB)

SW2-1 (SelA)

PCI Slot #

ON (down)

OFF (up)

ON (down)

OFF (up)