Seiko DH33 - Manual (Page 6)

10
English
11
English
● How to stop the regular alarm
The regular alarm rings at the designated time for 20 seconds
and stops. While the alarm is ringing, the regular alarm mark
flashes. To stop them manually, press button , ,
, or in any display.
● Alarm test
Press and hold buttons and at the same time in
the REGULAR ALARM or TIME/CALENDAR display.
Notes:
1. While you are underwater, the regular alarm rings for 3 seconds
and stops, but the regular alarm mark flashes for up to 20
seconds.
2. In testing the alarm, if button C is pressed just before pressing
button D, the engagement/disengagement of the regular alarm
and hourly time signal will be made. Show the REGULAR
ALARM display to engage or disengage them as required,
following the procedure above.
Press in the displays other than DIVE PLAN and
DIVE LOG to turn on the illuminating light.
• The display panel
is evenly
illuminated for 2
to 3 seconds.
Notes:
1. While the illuminating light is used, the watch may make a very
small noise. However, this is not a malfunction.
2. The electroluminescent panel loses its luminance as the battery
voltage becomes lower. Also, its luminance level decreases
gradually with use.
3. When the illuminating light becomes dim, replace the battery
with a new one. If the light remains dim after the battery is
replaced, have the electroluminescent panel replaced with a
new one by the retailer from whom the watch was purchased.
It will be replaced at cost.
HOW TO USE THE HOUR CORRECTION FUNCTION
Press to show HOUR CORRECTION display.
Press to show TIME DIFFERENCE SETTING display.
or Press to set the time/calendar of the
place you visit.
• “+” and “–”
appear near
buttons C and
D, respectively.
Current time
● When you travel around different time zones, the time/calendar of the place you visit can be set easily.
●
The time difference can be adjusted in 30 minute increments up to 24 hours. The calendar is also adjusted accordingly.
●
When you dive in a different time zone, it is recommended that you use this function to set the time/calendar of the diving site before
diving.
* With each press of buttons C or D, 30 minutes are increased
or decreased, respectively. The digits move quickly by keeping
the respective buttons pressed.
Press to return to HOUR CORRECTION display.
Notes:
1. For 10 minutes after a dive, the hour correction cannot be made.
2. If the watch is left untouched in the TIME DIFFERENCE SETTING
display, the display will automatically return to the TIME/
CALENDAR in 1 to 2 minutes.
3. Check that AM/PM and calendar are correctly set.
▼
▼
▼
■ ILLUMINATING LIGHT ■ HOUR CORRECTION FUNCTION
HOW TO USE TIME FUNCTIONS HOW TO USE TIME FUNCTIONS